Laing E10 Dimension One pump with control cable

Dostawa: 7 dni

This pump is a special version of the Laing E10 and is slightly more powerful. It includes both dry run protection and an integrated flow switch.

It is equipped with a small control cable and a standard power cable. It is found mainly on Dimension One brand spas marketed between 1998 and 2008, and some LA Spa, Saratoga, HotSpring and Sundance brand spas.

The E10 is quieter, offering a lower overall db level, than traditional induction pumps, eliminating the 48 frame growl. The permanent magnet design allows for the capture of 90% of the heat to be transferred into the water versus being lost to the air in waste.

The spherical rotor design has no shaft seals to leak or pump shaft to wear. The E10 weighs less than 4 pounds versus 14 pounds for standard induction pump motors.

The control cable has a 2-pin or -3-pin connector, depending on your control system.

Length: 152 mm
Width: 110 mm
Height: 125 mm

Technical data
Power rating: 70W
Flow rate : Approx. 40 litres/min

Discharge and suction: male nozzles with an outside diameter of 21 mm, which fit into a 3/4-inch flexible hose
Do not stick the hose to the pump: it is held in place with a collar

Cable and plug
This pump is delivered pre-cabled with an AMP plug (length 110 cm). You can also choose to have it pre-wired by our team with a 240 cm AMP plug or a mini J&J plug.

Spare parts
The only replacement part of the Laing E10 pump is the rotor assembly. It is available in two dimensions, Ø 68 mm and Ø 80 mm. Check the diameter of the part you want to replace!

1 year Tubs Parts warranty

Part numbers
Laing: 7387.1
Dimension One: 01512-320E

Plug types

AMP plug

AMP plug

J&J plug

J&J plug plug plug


Twój koszyk jest pusty

Wybierz pierwszy produkt